Xpresskit 20191108 User Manual

Rev.: 20191108
Platform: DBALL2
Firmware: BMW03
© 2019 Directed. All rights reserved.
30
86
85
87
87a
6 turns
6-8
turns
to pin 1: Black/White: Bypass Activation
(DBALL)
to pin 1: Black/White: Bypass Activation (DBALL)
(+) 12v
Immobilizer interface for Type 1
2. Loop immobilizer
IMPORTANT!: Not all OEM remotes can be inserted in TBXKEY because of their size.
Make sure that the key can be disassembled, otherwise it is recomanded to use
Loop Immobilizer installation.
NOTE: Your OEM remote may differ from the model shown in the illustrations.
PIN 5 Green
PIN 1 Black
PIN 6 Brown
PIN 4 Blue
PIN 2 Red
PIN 3 Violet
4
8
(+) 12 Volt Constant
Chassis Ground
1. Standard immobilizer interface with TBXKEY
TBXKEY are sold SEPARATELY. Request an order from Directed using the part numbers listed below.
UPC: 093207 062445
Move antenna loop as close to the front of
factory receiver ring as possible.
Test before closing installation.
Move antenna loop as close
to the front of factory receiver
ring as possible.
Test before closing installation.
- Make 6 loops and place them as close to the front of factory receiver ring as possible.
- Test and secure mounted loops before reassembling the vehicle.
- Make 6-8 loops and place them around the front of the plastic body of the vehicle’s coded key as shown above.
For vehicles with Keyless Entry you must remove battery from OEM Remote Control.
Page 3

Xpresskit 20191108 Specifications

General

Brand	Xpresskit
Model	20191108
Category	Automobile Accessories
Language	English