Rev.: 20191108
Platform: DBALL2
Firmware: BMW03
© 2019 Directed. All rights reserved.
Remote
Starter
10
Programming button
LED
14
122
5: Orange/Green: FT CAN High
6: Orange/Brown: FT CAN Low
7: Brown: NO Relay1
10: Orange/Red: NC Relay2
8: Yellow: COM Relay1
11: Yellow/Red: COM Relay2
RF Loop connector
Twisted pair in driver kick panel
CAN High: Orange/Green
CAN High: Black
CAN Low: Green
OR
CAN Low: Yellow
5 Series, 6 Series
1 Series, 3 Series,
X1, X5, X6, Z4
7: Gray/Black: (+) Ignition Status Output
11: Orange/Black: (-) KIBMW5 Output
12: Blue/Red: (-) KIBMW5 Output
3: Green/White: (-) KIBMW5 Output
4: Red/Black: (-) KIBMW5 Output
10: Yellow/Black: (+) KIBMW5 Output
P#: XKD2D65
D2D
D2D
5: Violet/White: (AC) Tach Output
2: Green/Black: (-) Handbrake Status Output
INSTALLATION - TYPE 2 (Manual Transmission)
(AC) Tach Input
(+) Ignition Input
(-) Ground
(-) Ground
(+) 12V
(+) 12 V
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
With the exception of the OBII Diagnotistic plug, all connectors are displayed from the wire side.
* - wire colours may vary by vehicle model
CUT
Located at
Clutch pedal
Clutch switch
Blue/Black*
Violet/Yellow*
Blue/Brown*
Brown/Black*
1
2
3
4
Blue/Black
Violet/Yellow
Blue/Brown
(-) Handbrake Status Input
BCM
Connections between
DBALL and KIBMW5
module are ready-made
KIBMW5 MODULE
(+) 12v
(-) Ground
Connect the KIBMW5 Cable to the key slot
after programming the DB-ALL module
12
turns
Make 12 loops and place them around
the front of the plastic body
of the vehicle’s coded key as shown.
1: Black/White: (-) KIBMW5 Output
Remove battery from
OEM Remote Control
Page 7
DBALL/
DBALL2
You must set “wait to start” feature menu at 10 seconds on your remote starter unit.
To Next Page
Loading...
Need help?
General
