37
values stored on ECU to the default state. Doing so can accurately
control the actions of regulating throttle (or idle engine) to adjust the
amount of air intake.
TPMS RESET
Tire Pressure Monitor System (TPMS) Reset allows you to quickly
lookup the tire sensor IDs from the vehicle ECU, as well as to perform
TPMS replacement and reset procedures after tire sensors are
replaced.
This function allows you to quickly look up the tire sensor IDs from the
vehicle’s ECU, as well as to perform TPMS replacement and sensor
tests.
After the tire pressure MIL turns on and maintenance is performed,
the tire pressure resetting function must be performed to reset tire
pressure and turn off the tire pressure MIL.
Tire pressure resetting must be performed after maintenance is
performed in the following cases: tire pressure is too low, tire leaks,
tire pressure monitoring device is replaced or installed, the tire is
replaced, the tire pressure sensor is damaged, and tire is replaced
for the car with tire pressure monitoring function.
ABS BLEEDING
Anti-lock Braking System (ABS) Bleeding allows you to perform
various bi-directional tests to check the operating conditions of ABS.
1. When the ABS contains air, the ABS bleeding function must be
performed to bleed the brake system to restore ABS brake sensitivity.
To Next Page
Loading...
Need help?
General
