Before resetting the gearbox, please check the gearbox control unit to ensure that
there is no fault code. If there is a fault code, the gearbox memory function cannot
be reset. Please road test after reset.
The operation guidelines of the Gearbox Matching function are shown
as below:
1. Enter the Gearbox matching menu and choose relevant models
according to the vehicle being tested.
2. Enter the Reset adaptive value menu.
3. Turn on the ignition without starting the engine.
4. Read the note and press OK to continue the Gearbox Matching
function.
5. Wait until the message ‘Successful operation’ popes up.
5.9 GEAR LEARNING
The crankshaft position sensor learns crankshaft tooth machining tolerance
and saves to the tablet to more accurately diagnose engine misfires. If gear
learning is not performed for a car equipped with a Delphi engine, the MIL
turns on after the engine is started. The diagnostic device detects the DTC
P1336 'Gear not learned'. In this case, you must use the diagnostic device
to perform gear learning for the car. After gear learning is successful, the
To Next Page
Loading...
Need help?
General