Multi 3630/3620 IDS Firmware update
ba77045d02 03/2020 37
8.2 Firmware update for the IDS WLM-M adapter
You can find available firmware update files for the IDS WLM-M adapter on the
Internet. With the Firmware Update program and a PC you can update the firm-
ware of an IDS WLM-M adapter to the newest version.
For updating, connect the IDS WLM-M adapter to the Multi 3630/3620 IDS with
a cable, and the Multi 3630/3620 IDS to a PC via the USB-B interface.
The update requires:
a free USB interface (virtual COM port) on the PC
the driver for the USB interface (on the enclosed CD-ROM)
the USB cable (included in the scope of delivery of the Multi 3630/
3620 IDS).
After switching the meter off and on you can check whether the IDS WLM-M
adapter has taken over the new software version:
Operation with OxiTop
®
-IDS measuring heads:
Menu <ENTER_> / Service information.
When operating with IDS sensors:
Menu <ENTER_> / System / Service information.
1.
Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the sensor (or sensor type), the
new data are displayed there.
2.
In the windows start menu, open the update folder and start the firm-
ware update program for the IDS sensor.
3.
Connect the IDS WLM-M adapter to the meter.
Only the connector in the lower section of the socket field (channel 1) is
suitable for the firmware update.
4.
Using the USB interface cable, connect the Multi 3630/3620 IDS to a
USB interface (virtual COM port) of the PC.
5.
Switch on the Multi 3630/3620 IDS.
6.
In the firmware update program, start the update process with OK.
7.
Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a
progress bar (in %) are displayed.
The programming process takes up to 5 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firm-
ware update is completed.
8.
Disconnect the Multi 3630/3620 IDS from the PC.
The meter and IDS WLM-M adapter are ready to operate.
To Next Page
Loading...
Need help?
General
