Trouble Recovery
65
EMU29510
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt/ the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit/the power tilt, the en-
gine can be tilted manually.
1. Loosen the manual valve screw by turn-
ing it clockwise until it stops.
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it counterclockwise.
EMU29531
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started with an emer-
gency starter rope.
WARNING
EWM01020
●
Use this procedure only in an emergen-
cy and only to return to port for repairs.
●
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
●
Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg while operating.
●
Do not attach the lanyard to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
●
Avoid accidentally pulling the lanyard
during normal operation. Loss of en-
1. Fuse box
2. Fuse (20 A)
3. Spare fuse (20 A)
4. Fuse puller
1. Fuse puller
1
2
3
4
ZMU04094
1
ZMU04093
1. Manual valve screw
1
ZMU04095
To Next Page
Loading...
