Yamaha LEXI User Manual

Periodic maintenance and adjustment
9-32
9
NOTICE
ECAU0081
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the panel.
EAUN1980
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Remove panel C. (See page 9-8)
2. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
3. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
ECAU0091
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
5. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
6. Install the panel.
Rear turn signal light bulb
1. Remove panel C. (See page 9-8)
2. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise.
1. Tail/brake light bulb socket
1
UB4HEZE0.book Page 32 Wednesday, March 21, 2018 2:58 PM

Yamaha LEXI Specifications

General

Fuel System	Fuel Injection
Front Suspension	Telescopic Fork
Rear Suspension	Unit Swing
Fuel Tank Capacity	4.2 L
Lubrication System	Wet Sump
Ignition System	TCI
Frame Type	Underbone
Starter System	Electric
Transmission Type	Automatic V-belt
Front Brake	Single disc
Rear Brake	Drum
Clutch Type	Automatic centrifugal
Rear Tire	100/90-10 56J