EasyManuals Logo
Home>Yealink>IP Phone>SIP-T19P

Yealink SIP-T19P User Manual

Yealink SIP-T19P
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
User Guide for the SIP-T19P IP Phone
88
Accept Intercom
You can enable or disable the phone to automatically answer an incoming intercom call.
If Accept Intercom is enabled, the phone automatically answers an incoming intercom
call. If Accept Intercom is disabled, the phone rejects incoming intercom calls and sends
a busy message to the caller. Accept Intercom is enabled by default.
Note
Intercom Mute
You can mute or un-mute the microphone on the phone for intercom calls automatically.
If Intercom Mute is enabled, the microphone is muted for intercom calls. If Intercom
Mute is disabled, the microphone works for intercom calls. Intercom Mute is disabled by
default.
Intercom Tone
You can enable or disable the phone to play a warning tone when receiving an
intercom call. If Intercom Tone is enabled, the phone plays a warning tone before
answering the intercom call. If Intercom Tone is disabled, the phone automatically
answers the intercom call without warning. Intercom Tone is enabled by default.
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone automatically answers the intercom call and places the active call on hold. If
Intercom Barge is disabled, the phone handles an incoming intercom call like a waiting
call. Intercom Barge is disabled by default.
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from
the pre-configured multicast address(es) without involving SIP signaling. You can
specify up to 10 multicast addresses that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and
Paging Priority Active parameters configured via web user interface.
Your administrator can set a delay time before the phone automatically answers
intercom calls. Contact your system administrator for more information.

Other manuals for Yealink SIP-T19P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T19P and is the answer not in the manual?

Yealink SIP-T19P Specifications

General IconGeneral
SpeakerphoneYes
Voice codecsCNG, G.711, G.723, G.726, G.729ab, VAD
MountingDesk/Wall
Handset typeWired handset
Product typeIP Phone
Product colorBlack
Front cameraNo
Display resolution132 x 64 pixels
Lines quantity- lines
Phonebook capacity1000 entries
Number of VoIP accounts1
Security algorithms802.1x RADIUS, AES, HTTPS
Networking standardsIEEE 802.1p, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3, IEEE 802.3af, IEEE 802.3u
Supported network protocolsIPv6
Ethernet LAN (RJ-45) ports2
Number of handles included- pc(s)
Operating temperature (T-T)-10 - 50 °C
Operating relative humidity (H-H)10 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth188 mm
Width185 mm
Height143 mm

Related product manuals