Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
355
0 to 2 (for T21(P) E2)
0, 1 (for CP920)
Default
Blank
Supported
Devices
All phones except T19(P) E2
Web UI
Settings > Dial Plan > Dial Now > Account
Parameter
phone_setting.dialnow_delay <y0000000000xx>.cfg
Description
It configures the delay time (in seconds) for the dial now rule.
When entered numbers match the predefined dial now rule, the phone will automatically dial out the
entered number after the designated delay time.
If it is set to 0, the phone will automatically dial out the entered number immediately.
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
Integer from 0 to 14
Default
1
Web UI
Features > General Information > Time Out for Dial Now Rule
Parameter
dialplan_dialnow.url <y0000000000xx>.cfg
Description
It configures the access URL of the dial now template file.
For customizing dial now template file, refer to Dial Now File Customization.
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
String within 511 characters
Default
Blank
Parameter
dialplan.transfer.mode <y0000000000xx>.cfg
Description
It configures the transfer type the phone will perform when the entered transferee numbers match the
Dial Now rule of the dial plan or the predefined string of the digit map.
Permitted
Values
0-Semi-attended Transfer/Attended Transfer
1-Blind Transfer
Default
0
Related
Parameters
dialplan.dialnow.rule.X
dialplan.digitmap.string
account.X.dialplan.digitmap.string
[1]
X is from 1 to 100.
Area Code Configuration
The following table lists the parameters you can use to configure the area code.
Parameter
dialplan.area_code.code <y0000000000xx>.cfg
Description
It configures the area code to be added before the entered numbers when dialing out.
To Next Page
Loading...
Need help?
General
