USB Interface 10 - 3
USB Host Parameters
USB Device Type
Select the desired USB device type. To select a country keyboard type for the USB HID Keyboard host, see
Appendix B, Country Codes.
NOTE When changing USB Device Types, the imager automatically resets and issues the standard startup beep
sequences.
NOTE Before selecting USB CDC Host, install the Zebra USB CDC driver located at
https://www.zebra.com/us/en/support-downloads/software/drivers/usb-cdc-driver.html on the host.
• If using Windows XP, this self-contained driver provides functionality but prompts with a warning
message as Microsoft no longer re-certifies drivers for this operating system.
• Windows 10 includes a native CDC driver that supports Zebra scanners. Use this to provide CDC
functionality in the Windows 10 environment.
To recover a stalled decoder:
• Install the Zebra USB CDC driver
or
After power-up, hold the trigger for 10 seconds, which allows the decoder to power up using an alternate
USB configuration. Upon power-up, scan another USB Device Type.
NOTE The SSI over USB CDC option enables a subset of the SSI protocol over the USB CDC interface which
omits all hardware handshaking functionality. For more information refer to the SSI Programmer's Guide.
NOTE Select IBM Hand-held USB to disable data transmission when an IBM register issues a Scan Disable
command. Aim, illumination, and decoding is still permitted. Select OPOS (IBM Hand-held with Full
Disable) to completely shut off the imager when an IBM register issues a Scan Disable command,
including aim, illumination, decoding and data transmission.
*USB HID Keyboard
Symbol Native API (SNAPI) with Imaging Interface
Symbol Native API (SNAPI) without Imaging Interface
To Next Page
Loading...
Need help?
General
