39
Your scooter requires a minimal amount of care and maintenance. If you do not
feel confident in your ability to perform the maintenance listed below, you may
schedule inspection and maintenance at your authorized Zipr provider.
TIRE PRESSURE
If equipped with pneumatic tires always maintain proper tire pressure.
Regularly inspect your scooter’s tires for signs of wear.
WARNING! Overinflating a tire can cause it to explode.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of
rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl
seat or tire tread; they will become dangerously slippery.
BATTERY TERMINAL CONNECTIUONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face the rear of the scooter.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for
wear or damage.
Have your authorized Zipr provider repair or replace any damaged
connector, connection, or insulation that you find before using your
scooter again.
ABS PLASTIC SHROUDS
The front tiller shroud, front shroud, and the rear shroud are formed from
durable ABS plastic and coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all pre-lubricated, sealed, and require no subsequent
lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly.
They should be inspected periodically for wear by your Zipr provider.
CONSOLE, CHARGER, AND ELECTRONIC’S MODULE
Keep these areas free of moisture. Allow these areas to dry thoroughly if
they have been exposed to moisture before operating your scooter again.
CARE & MAINTENANCE
To Next Page
Loading...
Need help?
General
