Page 20 of 24 HydroTap Installation and Operating Instructions - 89650UK - August 2011 v1.02
Activating ‘Sleep-when-it’s-dark’ feature
This feature will automatically switch the unit into Sleep mode Option 1 when
the ambient light falls below a set level. For this system to operate correctly
the sensor in the tap head must be calibrated for it’s surroundings.
Activation: This can only be achieved through the service mode.
To access the service mode
Press both the Adjust
>
and Adjust
>
buttons simultaneously and hold for
several seconds, until the screen displays the HOT and COLD temperatures.
Press the Menu
>
button once to display the Auto Sleep screen.
Press the Adjust
>
button or Adjust
>
button to select Enable or Disable.
Only after Enable has been selected can the tap head sensor be calibrated.
To Calibrate the sensor
Pull both the HOT and COLD levers forward while simultaneously pressing
the safety button. All the lights will flash, hold for approximately 1 second (3
flashes) and then release.
The sensor is now calibrated for it’s surroundings. If there is any confusion
with the surrounding light, the system will revert to Normal operation mode.
To exit from the Service mode Press both the Adjust
>
and Adjust
>
buttons
simultaneously and the screen will display Normal Operation. If the buttons are
not pressed together at the same time, the Disabled option may be selected. It
is important to watch the screen to ensure the system remains Enabled during
the exit procedure. Check for correct operation by turning off the surrounding
lights.
NOTE: When the system has entered sleep mode, due to low light conditions,
the screen will display ‘In Sleep Mode’. Operation of the Hot lever or an
increase in the ambient light, will temporarily take the system out of sleep.
Activating 7 Day Timer On / Off Mode
Press the Menu
>
or Menu
>
button until “Monday On” is displayed. To set
the time for the unit to turn on press
>
Adjust button until required time is
reached.
To set the time for the unit to turn Off press Menu
>
button once and
“Monday Off” will be displayed. Now press
>
Adjust until required time is
reached.
If each individual day is to have an “On / Off” time, these steps need to be
repeated for each day and for each On / Off time.
Setting the Energy Saver Timer
(continued)
Note:
The Hydrotap may be
temporarily activated by
operating the HydroTap levers,
the unit will go into normal
operation and then remain in an
“ON” cycle, until the next “OFF”
cycle.
To Next Page
Loading...
Need help?
General
