HydroTap Installation and Operating Instructions - 89650UK - August 2011 v1.02 Page 11 of 24
ROTATE for Hot / Cold water
LIFT OR LOWER HANDLE for ON /OFF water flow
Hot Temp Lvl
Cold Temp Lvl
NOTE: The temperatures shown are actual, not the set temperatures. To revert back to the Normal Operation screen,
press the adjust buttons together again until screen changes.
Press the Menu plus button, once, to enter the Hot Temperature Adjustment Screen:
Here you can adjust the Hot temperature set point by pressing the A adjust
>
or
>
buttons The Hot temperature set
point can be raised or lowered in 0.5ºC increments between 68º - 100ºC. Note: the Maximum setting of 100ºC is not
recommended for normal use. Do not raise temperature above 98.5ºC without consulting Zip first to discuss the service
issue.
Press the Menu minus button, once, to return to the service default screen:
To change the service default screen back to Normal Operation, press the adjust buttons together until the screen
changes back.
Caution
must be observed when changing any settings within the Service Menu as changes
may affect the normal operation of the unit.
Installation Procedure
(continued)
Operating the Mixer tap
The Mixer tap is operated as a conventional ‘Flick Mixer’
Lifting the handle up will decrease the flow rate and lowering the handle will increase the flow rate. Lift the handle all the
way up to turn the tap off.
When the handle is moved to the left, the temperature is decreased and when moved to the right the temperature is
increased. The final temperature will be dependant on the temperature of the incoming cold water.
The spout may be swivelled, left or right, for convenience
Hot Temp Lvl
Cold Temp Lvl
Menu plus
Menu minus
A
A
To Next Page
Loading...
Need help?
General
