Getting to know your Mobile Cam
13
1. SIM/USIM card slot 2. T-Flash card slot 3. Reset
4. Power 5. Clear 6. Speaker 7. Charger Connector
On the back of the unit, there are 3 slots: SIM/USIM, T-Flash and charger. Please refer to 1.5.1,
1.5.2 and 1.5.4 respectively for details. There are also 3 buttons:
RESET: Restart the system. White list and password will not be affected.
CLEAR: Press for over 3 seconds to clear all white list numbers except the administrator
number. Password will not be affected.
POWER: Power on/off.
2.5 Getting started
Make sure you follow the operation procedure before using the Mobile Cam.
Insert a 3G SIM/USIM card.
The battery should be fully charged before you use the Mobile Cam, otherwise the Mobile
Cam may not function correctly.
Set date and time. See details in Section 4.2.
2.5.1 SIM/USIM card
Be sure to insert a 3G SIM/USIM card before you use the Mobile Cam.
Note:
A SIM/USIM card set with PIN code cannot be used normally in the Mobile Cam. You need
to use another mobile phone to unlock the PIN code of the SIM/USIM card before using it
in the Mobile Cam.
To Next Page
Loading...
Need help?
General