White list
21
Note:
Once you set the AD number on the Mobile Cam, you can check or revise the time by SMS. For
details, please refer to the section on SMS command operation.
The AD number should be set in WCDMA network, using a local number. An attempt to set the
number from outside local network using a mobile roaming or IDD service will result in an
invalid number being saved in the white list.
3.3 Setting other user numbers
In addition to the AD, other phone numbers will be added to the white list (maximum 20
numbers in the white list, except the AD) when making a video call to the Mobile Cam with a
correct PIN code entered.
First, make a video call to the Mobile Cam using a non-AD number.
When the call connects, the screen will prompt you to enter a PIN code. A “beep” sound from
the Mobile Cam indicates that the video call has been successfully connected. If you make 3
consecutive incorrect PIN code entries, or have not been able to enter the PIN code within 60
seconds, the Mobile Cam will be disconnected automatically. If the PIN code is valid, the user
will enter the video call interface.
The AD can also set the other user number via the video phone menu or SMS commands (see
Section 4.1, 4.2). AD can also set validation for non-white list users (see Chapter 5).
To Next Page
Loading...
Need help?
General