To Next Page

To Previous Page

6 Configure the Local Network

2. To enable the DHCPv6 and RA function, select the corresponding LAN interface or

SSID.

Note

 Click All On to select all IPv6 Service-Port control types.

 Click All Off to cancel all IPv6 Service-Port control types.

3. Click Apply button to apply the changes.

6.4 Configure the Route

6.4.1 Configure the Routing(IPv4)

The section describes how to configure routing(IPv4), which provides the parameters of

route(IPv4) configuration features.

The relevant information of Internet status includes Routing Table, Static Routing and

Policy Routing.

Prerequisite

Before configuring routing(IPv4), make sure that the IPv4 WAN connection is created.

Steps

Routing Table

1. On the main page of the ZXHN H3601, select Local Network > Routing > IPv4 to

the Routing(IPv4) page.

2. Click Routing Table to the configuration page, see Figure 6-17.

Figure 6-17 Routing Table Page

3. Click Refresh to refresh the information.

Static Routing

SJ-20200429083356-004 | 2020-07-23(R1.0) 6-15

Questions and Answers:

Need help?

Do you have a question about the Zte ZXHN H3601 and is the answer not in the manual?

Zte ZXHN H3601 Specifications

General