38 CHAPTER 3: SETTING UP FOR MANAGEMENT
top-level menu of the command line interface is displayed as shown in
the example in Figure 10
.
Figure 10 Example top-level command line interface menu
4 At the Select menu option prompt you can either:
■ enter the protocol ip basicConfig command. At the Enter
configuration method prompt enter manual. The screen
prompts you to enter IP information.
or
■ enter the gettingStarted command. At the Enter
configuration method prompt enter manual. The screen
prompts you to enter IP information.
5 Enter the IP address, subnet mask, and gateway IP address for the Switch.
The screen displays a summary of the information entered.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See “Methods of
Managing a Switch” on page 45.
Connecting to the
Console Port
To set up your Switch manually you can alternatively make a connection
to the console port (this example describes a local connection to the
console port, rather than a remote one via a modem). You can do this
whilst the Switch is offline, that is, before you connect the Switch to a
network, or whilst the Switch is online, that is, connected to a network.
Menu options: --------------3Com Superstack 3 Switch 4200---------------
bridge - Administer bridge-wide parameters
gettingStarted - Basic device configuration
logout - Logout of the Command Line Interface
physicalInterface - Administer physical interfaces
protocol - Administer protocols
security - Administer security
system - Administer sytem-level functions
trafficManagement - Administer traffic management
Type ? For help
-------------------------------(1)-----------------------------------
Select menu option:
DUA1730-0AAA04.book Page 38 Thursday, November 17, 2005 2:59 PM
To Next Page
Loading...
Need help?
General