ABB AC 900F User Manual

CP-C switch-mode power supply units and CP-C RU redundancy unit Section 5 Mounting
74 M&I – AC 900F Controller
CP-C switch-mode power supply units and CP-C RU redundancy unit
The CP-C 24/5.0, CP-C 24/10.0 and CP-C RU modules are installed in four steps:
1. Slightly tilt the module and place it on the DIN rail (horizontal mounting
position, input terminals at the top).
2. Move the module downwards up to the stop.
3. Press against the front side to lock the module in place.
4. Slightly shake the module to check whether it is correctly locked.
PS_Mount_us.png
To remove the CP-C or CP-C RU, proceed as follows:
1. Unlock the module using a screwdriver.
2. Tilt the module and remove it to the top.
PS_Dismount.png

ABB AC 900F Specifications

General

Brand	ABB
Model	AC 900F
Category	Controller
Language	English