Appendix A – ACS/ACC/ACP 601 Technical Data
ACS/ACC/ACP 601 Frequency Converters A-11
External Control
Connection Diagrams
External control connections of ACS 600 equipped with Standard
Application Program (Factory Macro) are shown below. External
control connections are different with other application macros and
programs (see
Firmware Manual
). External control wiring is connected
directly to terminals on the NIOC board.
External control wiring of ACP 600 is connected either directly to
terminals on the NIOC board or the NIOCP board. External control
connections to NIOCP board are shown below.
When making the external control connections be sure to carefully
compare the terminal configuration found in the drive with diagrams
below to be sure that the correct diagram is used.
To Next Page
Loading...
Need help?
General
