About this manual
19
About this manual
What this chapter contains
This chapter describes the intended audience and contents of this manual. It
contains a flowchart of steps in checking the delivery, installing and commissioning
the drive. The flowchart refers to chapters/sections in this manual and other
manuals.
Intended audience
This manual is intended for people who plan the installation, install, commission, use
and service the drive. Read the manual before working on the drive. The reader is
expected to know the fundamentals of electricity, wiring, electrical components and
electrical schematic symbols.
This manual is written for readers worldwide. Both SI and imperial units are shown.
Special US instructions for installations within the United States that must be
installed per the National Electrical Code and local codes are marked with (US).
Other related manuals
Refer to ACS800 IGBT Supply Control Program Firmware Manual [3AFE68315735
(English)] for the line-side converter
• program features
• actual signals and parameters
• fault tracing
• fieldbus control.
Note: The parameters of the line-side converter control program need not be
set in a normal start-up procedure or in normal use.
See the appropriate application program firmware manual for the motor-side
converter
• start-up procedure
• use of the control panel
• program features
• actual signals and parameters
• fault tracing
• fieldbus control.
Note: The ACS800-11/U11 specific parameters are described in the hardware
manual in chapter Operation.
To Next Page
Loading...
Need help?
General