ABB ACS800-11 User Manual

Operation
82
Fault tracing
Flashing messages WARNING, ID:2 or FAULT, ID:2 on the control panel display
indicate a warning or fault state in the line-side converter when the control panel
controls the motor-side converter:
To display the warning or fault identification text, shift the control panel to view the
line-side converter as described in section Changing the control panel to the line-
side converter.
Fault: Same ID numbers
If the ID numbers of the line-side and the motor-side converters are set equal, the
control panel stops functioning. To clear the situation:
• Disconnect the panel cable from the RMIO board of motor-side converter.
• Set the ID number of the line-side converter RMIO board to 2. For the setting
procedure, see the application program firmware manual.
• Connect the disconnected cable to the RMIO board of the motor-side converter
again and set the ID number to 1.
Changing the control panel to the line-side converter
WARNING! The drive does not stop by pressing the control panel Stop key in local
control mode.
Step Action Press key Display (example)
1. To enter the Drive Selection Mode
Note: In local control mode, the motor-side converter trips
if parameter 30.02 PANEL LOSS is set to FAULT. Refer to
the appropriate application program firmware manual.
2. To scroll to ID number 2
3. To verify the change to the line-side converter and display
the warning or fault text
FAULT, ID:2
ACS 800 0050_5MR
*** FAULT ***
LINE CONV (FF51)
DRIVE
ACS 800 0050_5MR
ASXR7xxx
ID-NUMBER 1
ACS 800 0050_5LR
IXXR7xxx
ID-NUMBER 2
ACT
ACS 800 0050_5LR
DC OVERVOLT (3210)
2 -> 380.0 V
** FAULT **

ABB ACS800-11 Specifications

General

Brand	ABB
Model	ACS800-11
Category	DC Drives
Language	English