362 Technical data
Ethernet link
Installation Into an option slot on the drive control unit
Degree of protection IP20
Ambient conditions The applicable ambient conditions specified for
the drive in its manuals are in effect.
Package Cardboard. Plastic wrapping: Antistatic air bubble
sheet (PE).
Indicators Three bicolor LEDs (HOST, MODULE,
NETWORK/NET)
Connectors A 20-pin connector to the drive
RJ-45 connector to Ethernet (X1)
FENA-21 only:
RJ-45 connector for chaining
another adapter module (X2)
Power supply +3.3 V
±5% max. 400 mA (supplied by the drive)
General Complies with EMC standard EN 61800-3:2004
Printed circuit board conformal coated
Compatible devices Ethernet Standard IEEE 802.3 and IEEE 802.3u
devices
Medium 10BASE-TX or 100Base-TX with Auto-
negotiation and Auto-MDIX (Auto-crossover)
• Wiring: CAT5/6 UTP, CAT5/6 FTP, CAT5/6
STP
• Connector: RJ-45
• Termination: Internal
• Maximum segment length: 100 m / 328 ft
Topology Bus or star.
Max. 50 nodes allowed for FENA-21 in a daisy
chain topology.
Transfer rate 10 Mbps or 100 Mbps
Serial communication
type
Half or full duplex
Protocol Modbus/TCP, EtherNet/IP, PROFINET IO
To Next Page
Loading...
Need help?
General
