ABB PGC5000 Series User Manual

PGC5000
PGC5000 Series Service Instructions 7 Subassembly repair
SI/PGC5000-EN, Rev B 62
7.5.3 Replacing the burner block o-rings
Refer to Figure 7.7 when performing this procedure.
Perform steps 1 through 4 of "Replacing the Burner Block."
To remove a particular O-Ring, carefully remove the associated connector and then remove the O-Ring.
O-Ring
45051-4-102
Adapt er
Jet
O-Ring
45051-4-106
O-Ring
45051-5-18
Fig. 7.7. Burner Block Cross Section (showing O-rings)
1. Perform steps 1 through 4 of “Replacing the Burner Block.”
2. To remove a particular o-ring, carefully remove the associated connector and then remove the o-ring.
3. Lubricate the new O-Ring with a slight film of silicone grease.
4. Insert the new O-Ring and reinstall the connector.
7.5.4 Replacing the jet
Refer to Figure 7.7 when performing this procedure.
1. Perform steps 1 through 4 of "Replacing the Burner Block."
2. Carefully remove the Adapter.
3. If the Jet came out with the Electrode Nut, carefully remove the Jet from the Electrode Nut.
4. If the Jet did not come out with the Adapter, carefully remove the Jet from the Burner Block by pulling it straight down.
5. Insert the new Jet into the Electrode Nut until it seats fully.
6. Carefully install and tighten the Electrode Nut.

ABB PGC5000 Series Specifications

General

Brand	ABB
Model	PGC5000 Series
Category	Laboratory Equipment
Language	English