ABB PGC5000 Series User Manual

PGC5000
PGC5000 Series Service Instructions 8 Replacement parts
SI/PGC5000-EN, Rev B 76
8.1.3 Oven configuration identification
The Oven nameplate (see Figure 8.2) lists the Oven configuration information.
Mode l
Num ber
Sales Order
Num ber
Fig. 8.2. Typical Oven Nameplate
8.1.4 Software configuration identification
The software version appears on the Setup>Master Controller>SBC Config Subtab (see Figure 8.3).
Fig. 8.3. Software Configuration Identification
8.1.5 How to order
Please contact your local ABB sales or service representative for specific instructions on ordering parts. Always include the
information listed in Equipment Identification and Configuration Identification in your request.
The remainder of this section lists the replaceable parts and components by their location in the equipment. Part numbers and
drawing numbers listed here are for identification purposes only. When you order parts for replacement, use the list of parts
included in the Engineering Data Package provided with your equipment to ensure you have the correct version of each part.

ABB PGC5000 Series Specifications

General

Brand	ABB
Model	PGC5000 Series
Category	Laboratory Equipment
Language	English