ABB REB500 User Manual

1MRK 500 124-UEN Section 6
Troubleshooting
Operation Manual 87
Distributed busbar protection REB500
4.
Invalid Time Stamps
Wrong time
synchronization type
and/or parameter
Check time
synchronization type
and/or p
arameter
Wrong time master
configuration
Check time master
configuration
Wrong LWL connections
Check LWL connections
to time master
5.
Hardware M
ismatch Alarm
Wrong hardware installed
Replace Hardware with
configured type.
Wrong hardware type
configured
Change the configuration
6.
IP address conflict
Ethernet interface LAN0
has address configured
which already exists in the
network connected to this
interface
Change configured IP
address
7.
RPB Interruption Alarm on BU
Process Bus connection
interrupted
Check proce
ss bus
connection
(see Section 2)
CU is offline (e.g. during a
CU restart)
Wait until CU is up and
running again (up to 3
Minutes)
BU is stuck in standalone
mode
Restart the BU
8.
RPB Interruption Alarm on CU
At least
one of the two
process bus links of the
CU is interrupted
Check both
process bus
links (see Section 2)
6.2.4 Optical fiber connections faults
Description Possible Cause Corrective Action
1.
Process Bus:
No link LED for a
connected BU
Optical fiber defect, or wrong
type
Check, replace optical fibers
Optical fiber wrong
connection
Check connection
2.
IEC 61850 Bus
No link LED for a
connected station control
system
Optical fiber defect, or wrong
type
Check, replace optical fibers
Optical fiber wrong
connection
Check connection
3.
IEC 103 RX/TX LED dose
not blink
Optical fiber defect, or wrong
type
Check optical fibers
Optical fiber wrong
connection
Check
optical fiber
connections
Wrong IEC103 Configuration
Check IEC103 Configuration

ABB REB500 Specifications

General

Brand	ABB
Model	REB500
Category	Protection Device
Language	English