3
31
3 Setting Up the Micropump System
3.1 Recharging the Battery
Before you start using the diabetes manager, you must charge
the battery.
Connect the diabetes manager to a PC or charger using the USB
cable. The preferred method is to use a charger and wall socket
since charging takes less time this way. It takes approx. 4 hours
to charge a fully drained battery using a charger that is
connected to a wall socket. Charging the battery using the USB
connector on a PC may take longer. Note
j While the diabetes manager is being charged, you cannot
perform any blood glucose tests.
j Recharge the battery regularly so that it does not become
fully drained. Keeping the diabetes manager plugged in for
a longer period to charge does not harm the battery.
j Check regularly whether the time and date of the diabetes
manager are set correctly.
wWARNING
j Use only the supplied charger with the appropriate USB
cable.
j Use only the rechargeable battery from Roche.
Symbols for dierent battery levels:
low
20% 40% 60% 80% 100%
man_07866364001_A_en.indb 31 28.07.2017 12:15:51
To Next Page
Loading...
Need help?
General
