3-86 Machine Maintenance
External Module Reassembly Process 0
Replacing the Memory Modules 0
1. Insert the memory module at a 30° angle into the ADM2 memory slot (a) and then press it
down until it clicks into place (b).
The module is keyed so it can only be inserted in one direction. If the module does not fit,
make sure that the notch in the module lines up with the tab in the memory slot.
Figure 3-132. DM2 Slot Module
2. If a second memory module is available, install it in the DM1 slot by repeating step 1.
Figure 3-133. DM1 Slot Module