2-10 System Utilities
Removing a Password 0
Perform the following:
1. Use the and keys to highlight Set Supervisor Password and press Enter. The
Set Supervisor Password dialog box is shown. (Figure 2-5)
Figure 2-5. Removing a Password: Set Supervisor Password
2. Type current password in Enter Current Password field and press Enter.
3. Press Enter twice
without typing anything in Enter New Password and Confirm New
Password fields. Computer will set Supervisor Password parameter to Clear.
4. Press F10 to save changes and exit the BIOS Setup Utility.
Changing a Password 0
1. Use the and keys to highlight Set Supervisor Password and press Enter. The
Set Supervisor Password dialog is shown. (Figure 2-6)
Figure 2-6. Changing a Password: Set Supervisor Password
2. Type current password in Enter Current Password field and press Enter.
3. Type new password in Enter New Password field and press Enter.
4. Retype new password in Confirm New Password field and press Enter.
5. If new password and confirm new password strings match, The Setup Notice dialog is
shown (Figure 2-7). If it is not shown, go to step 6.
Set Supervisor Password
Enter Current Password [ ]Enter Current Password
Enter New Password [ ]
Confirm New Password [ ]
Set Supervisor Password
Enter Current Password [ ]Enter Current Password
Enter New Password [ ]
Confirm New Password [ ]
SG_JV51_HR.book Page 10 Friday, July 8, 2011 5:58 PM
To Next Page
Loading...
Need help?
General
