User's Manual | ACOM 1200S | 1.8-54 MHz Linear Power Amplifier
S e c t i o n GENERAL INFORMATION | Page
11
of
60
1.5. Safety Considerations, Explicit Definitions
The ACOM 1200S linear power amplifier is a Safety Class I unit regarding protection against electric shock.
The third grounding lead of its mains cord (which is colored yellow with two green stripes) and the ground
stud on the rear panel of the amplifier (marked GND, see Figure 2-2 Rear panel - Connections, Pos. (a)) must
be connected to the station's grounding system for safe operation.
The amplifier is designed to meet international safety standards and complies with the CE safety and
electromagnetic compatibility requirements, as well as the FCC regulations.
This User's Manual contains information, warnings (signal words Danger, Warning, Caution and Notice)
and instructions, related to hazards, that should be followed by the user in order to ensure safe operation
and to keep the amplifier in a safe working condition at all times.
The EXPLICIT DEFINITIONS described below apply to this User's Manual:
DANGER
These notes call attention to a procedure or instructions which, if not correctly
performed, will result in serious personal injuries and even death.
WARNING
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in serious personal injuries and even death.
CAUTION
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in minor or moderate personal injuries.
NOTICE
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in property damage or equipment damage not exclusively to
the amplifier but also to connected equipment.
To Next Page
Loading...
Need help?
General
