ACUTRONIC fabian +nCPAP evolution User Manual

12 Accessories and options 89
fabian +nCPAP evolution | SW V5.1.x
Ref: 122003.EN / Date : 26Jan2021
12.3 SpO
2
module
12.3.1 Setting up the Masimo sensor
To enable the SpO
2
measurement, the module must be enabled. This can be done in the menu
of the SpO
2
module.
Figure 12-1: Enable SpO
2
You can choose from the SpO
2
menu, different module settings described in the following
sections.
Figure 12-2: SpO
2
Settings and Information
Here, information on the sensor state and software release of the used module is displayed. You
can select the sensitivity mode, enable or disable Fast SAT mode, and set the Alarm Delay and
the SpO
2
Averaging Time.
The information on the sensor state is displayed in the configuration menu, in the information
bar at the bottom.
In addition, the following general messages for the sensor state can appear in the information
bar in the Configurations menu:
• "checking "
• "processing active "

ACUTRONIC fabian +nCPAP evolution Specifications

General

Brand	ACUTRONIC
Model	fabian +nCPAP evolution
Category	Medical Equipment
Language	English