Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 17
Getting Started with Remote Operation
Preferences
Configuring the Display for Remote Command Setups (Agilent MXG)
Configuring the Display for Remote Command Setups (ESG/PSG/E8663B)
For details on each key, use the key help (described in User’s Guide).
Select Update in Remote until On is
highlighted.
SCPI commands:
:DISPlay:REMote ON|OFF|1|0
:DISPlay:REMote?
For details on each key, use the Key and Data Field Reference. For additional SCPI command information, refer to the SCPI Command
Reference.
Select Update in Remote until On is highlighted.
SCPI commands:
:DISPlay:REMote ON|OFF|1|0
:DISPlay:REMote?
Using the Update in Remote softkey updates the display but not the
softkeys on each SCPI command.
In general, the softkeys are not updated until the SCPI command
SYST:DISP:GTL is sent.
To Next Page
Loading...
Need help?
General
