Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 261
Creating and Downloading Waveform Files
Programming Examples
NOTE For the Agilent MXG, the SOURce:FREQuency 20000000000 value must be changed as
required in the following programs. For more information, refer to the Data Sheet.
barker.m This programming example calculates and downloads an arbitrary waveform file
that simulates a simple 7–bit barker RADAR signal to the PSG vector signal
generator.
chirp.m This programming example calculates and downloads an arbitrary waveform file
that simulates a simple compressed pulse RADAR signal using linear FM chirp to
the PSG vector signal generator.
FM.m This programming example calculates and downloads an arbitrary waveform file
that simulates a single tone FM signal with a rate of 6 KHz, deviation of
=/– 14.3 KHz, Bessel null of dev/rate=2.404 to the Agilent MXG/PSG vector signal
generator.
nchirp.m This programming example calculates and downloads an arbitrary waveform file
that simulates a simple compressed pulse RADAR signal using non- linear FM
chirp to the PSG vector signal generator.
pulse.m This programming example calculates and downloads an arbitrary waveform file
that simulates a simple pulse signal to the PSG vector signal generator.
pulsedroop.m This programming example calculates and downloads an arbitrary waveform file
that simulates a simple pulse signal with pulse droop to the PSG vector signal
generator.
To Next Page
Loading...
Need help?
General
