Agilent InfinityLab LC Series Multicolumn Thermostats User Manual 70
3 Using the Module
Installing and Using Column ID Tags
Connecting the Column ID Tags
1 If the column has no Column ID Tag, fit a tag by slipping
the loop over one end of the column and pulling it tight
through the plastic holder.
NOT E
Once the loop has been pulled tight, the tag can no longer be
removed from the column.
2 Install the column in the column compartment, see
“Exchange a Column” on page 52.
3 Plug the free end of the Column ID Tag into the adjacent
socket in the column tag reader unit.
NOT E
It is important that the Column ID Tag is plugged into the
adjacent socket in a logical order (that is, first column from
the top into "1", second column from the top into "2", and so
on). Otherwise, it is easy to confuse the columns and their
locations during column assignment in a CDS.
NOT E
If you have a full-length column, we recommend that you use the adjacent socket
on the left column tag reader.
To Next Page
Loading...
Need help?
General
