AFTER SALES SUPPORT
(toll free)
224cc 4 Stroke Petrol Lawn Mower
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL No.: SLM531 • 10/2020 • 10093
35
R1
Maintenance
2. Remove the oil drain plug (18) bolt, (Fig. R1)
using a 10mm spanner (not supplied) in an anti-
clockwise direction to loosen. (Fig. R2)
WARNING: Oil may be hot.
3. Drain the oil into a suitable / approved container
for the disposal of oils and the like.
4. After the oil has drained, install and tighten the oil
drain plug (18) bolt. Wipe up any spilt oil.
5. To rell the oil tank, follow the process on page 26.
NOTE: Please dispose of used engine oil in a manner
that is compatible with the environment. We suggest
you take it in a sealed container to your local service
station for reclamation. Do not throw it in the trash,
pour it into the earth, or pour down drains.
Air Cleaner Maintenance
The air cleaner system uses a pleated lter.
IMPORTANT A dirty air lter (35) will
restrict air ow to the carburettor.
To prevent carburettor malfunction, service the air
lter (35) regularly.
Check that the air lter (35) is clean and dry of dirt.
Filters thick with debris will not allow the engine
to breathe and result in dicult starting and poor
engine performance.
The air lter (35) should be checked after
approximately 25 hours of use, or annually.
1. Refer to Adjusting the Cutting Height section in
Preparing for Operation part on Page 28 to set
the height to the hightest level, in order to avoid
interference between the air lter cover (12) and
the bar (a) above the deck. (Fig. S1)
2. Open the air lter cover (12) by pushing in the rear
tab (right hand side) to release the clip, and then
S2
S1
R2
To Next Page
Loading...
Need help?
General
