The
provides 6 mono and 2 dual stereo channels. The 6 mono channels accept either a
microphone or a line level signal. The microphone inputs are balanced XLR with globally
switched +48V phantom powering. The line inputs are balanced 3-pole TRS (Tip Ring Sleeve)
phone jack and can accept balanced or unbalanced signals. The 2 stereo channels include an
XLR mic input so that the
can be used as an 8 input microphone mixer if required. Each
has two stereo line inputs which combine to allow two sources to use the same channel
simultaneously, for example a keyboard and additional voice module, or a stereo guitar
processor and a CD player. One input is on a pair of TRS phone jacks, the other on RCA
phono pin jacks. The stereo signal can be switched for mono operation. A further two
dedicated stereo channels are included for the built-in effects processors FX1 and FX2. This
allows up to 14 inputs to be connected to the 8 channels of the
with control of 18 signals
in the mix.
The
provides four output mixes: the main LR stereo mix, FB foldback monitor mix and
the AUX output which can be configured pre or post channel fader. These mixes are available
on TRS jack outputs and can also be configured as required to the two amplifier outputs A and
B. The LR mix is summed to an additional mono output jack. The DP1000 has a built in dual
power amplifier with outputs on Speakon
®
connectors. The DL1000 has two balanced XLR
outputs to feed external amplifiers. The AB outputs can be configured as :
•
Stereo mode = PA with separate left and right outputs
•
Split mode = mono PA and single foldback monitor
•
Monitor mode = external PA and 2 foldback monitors
To Next Page
Loading...
Need help?
General
