The following diagrams illustrate how the icon can be used to drive additional amplifiers
where more loudspeakers and power are required. The
and
jack outputs can be plugged
into a graphic equaliser and amplifier to drive a front-of-house stereo speaker system while the
built-in amplifier is configured to provide two foldback monitors from the
and
mixes.
Use the
(mono) jack output to drive a centre fill or sub-bass speaker system. A stereo
amplifier can be configured or linked so that the mono signal feeds both channels. The
jack outputs can be used to drive additional amplifiers to supplement the built in amps.
These outputs are pre
level but follow the
graphic equalisers.
To Next Page
Loading...
Need help?
General
