P–2 Preface
Publication 1203–5.1 –– July, 1997
Contents of this Manual
This manual contains the following information:
Chapter: Title: Contents:
Preface
Describes the purpose, background, and scope of this
manual as well as an overview of this product.
1 Overview
Provides an overview of the adapter features,
configuration information, and diagnostic information.
2 Installation
Provides the procedures you need to mount the Bulletin
1203 remote I/O communications module, connect the
power, and configure the switches, as well as providing
cabling and hardware information.
3
Configuration and
Interfacing
Provides information such as addressing, information
transfer, and sample programs.
4 Troubleshooting
Provides information about the LED indications and
fault descriptions.
5 Specifications
Provides the environmental, electrical, and
communications specifications.
Please read the following safety precautions carefully.
!
ATTENTION: Only personnel familiar with
SCANport devices and the associated machinery
should plan or implement the installation, start-up,
configuration, and subsequent maintenance of this
remote I/O communications module. Failure to comply
may result in personal injury and/or equipment
damage.
!
ATTENTION: This module contains ESD
(Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required
when installing, testing, servicing, or repairing this
assembly. Component damage may result if ESD
control procedures are not followed. If you are not
familiar with static control procedures, reference
Allen-Bradley Publication 8000-4.5.2, Guarding
against Electrostatic Damage, or any other applicable
ESD protection handbook.
This manual supports communication module firmware versions
1.xx and 2.xx (the xx designator may vary). Features that work with
specific firmware versions will be denoted as such.
Safety Precautions
Firmware Support
To Next Page
Loading...
Need help?
General
