Rockwell Automation Publication 5069-UM004A-EN-P - April 2019 11
Preface
This manual describes how to use Compact 5000â„¢ I/O digital modules in
Logix 5000â„¢ control systems.
Make sure that you are familiar with the following:
• Use of a controller in a Logix 5000 control system.
• Use of an EtherNet/IP™ network, if the digital I/O modules are
used remotely.
• Use of safety systems.
• Use Studio 5000 Logix Designer® environment.
Summary of Changes
This manual was revised to add information listed in this table. Some minor
changes were made in the manual that are not listed here.
IMPORTANT In this manual, we use standard module to indicate a standard digital I/O
module. We use safety module to indicate a safety digital I/O module.
Further, we use Compact 5000 I/O digital module to indicate when a
concept or task applies to both the standard and safety digital I/O modules.
Topic Page
Added Compact 5000 I/O conformal coated digital modules, 5069-IB16K and 5069-OB16K Throughout
Secure Access to the System 28
Configuration Changes in an Input Module with Multiple Owners 30
Use a 5069-ARM Address Reserve Module to Reserve a Node Address 33
Power Requirements When You Use Compact 5000 I/O Safety Modules 37
Connections with Compact 5000 I/O Safety Modules 44
Considerations Specific to Safety Modules 58
Use with Safety Controllers 60
Safety Precautions 62
Safety Application Requirements 63
Safe State 64
Configuration Signature and Ownership 65
Reset Compact 5000 I/O Safety Modules to Out-of-Box State 65
Safety Module Features Chapter 5, page 133
Configure and Replace Safety Modules Chapter 7, page 191
Compact 5000 I/O Safety Input Module Status Indicators 219
Compact 5000 I/O Safety Output Module Status Indicators 221
5069-IB8S and 5069-IB8SK Module Tags 268
5069-OBV8S and 5069-OBV8SK Module Tags 270
Application and Wiring Examples for Safety Modules Appendix C, page 273
Safety Data for Safety Modules Appendix D, page 287
To Next Page
Loading...
Need help?
General
