6 Rockwell Automation Publication 750-RM003A-EN-P - April 2018
Preface
Parameter References
PowerFlex 700AFE parameters are referenced in the format Pxxx [name], By,
where:
• xxx is the parameter number
•[name] is the parameter display name
• y is the bit number (if applicable)
In this document, PowerFlex 755T ports, parameters, and bits are referenced in
the format #:x.y [name], where:
•# is the port number
• x is the parameter number
• [name] is the parameter display name
• y is the bit number (if applicable).
General Precautions
Be aware of the following general precautions when working with this type of
equipment. See the installation instructions for each bus supply for additional
product-specific precautions. Applicable publication information can be found
in Additional Resources
on page 10.
EXAMPLE For example; referencing an I/O module that is installed in port 4,
parameter 6 [Dig Out Invert], bit 1 (TransOut0) can be shown as 04:0006.01
[Dig Out Invert].
The leading zeroes and [name] can be omitted unless required to clarify the
context.
This parameter can also be shown as 4:6.1, 4:6.01 [Dig Out Invert] or any
other combination that shows the minimum port:parameter information.
ATTENTION: Only qualified personnel familiar with adjustable frequency AC
drives and associated machinery should plan or implement the installation,
startup, and subsequent maintenance of the system. Failure to comply can
result in personal injury and/or equipment change.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing,
testing, servicing or repairing this assembly. Component damage may result
if ESD control procedures are not followed. If you are not familiar with static
control procedures, reference Guarding Against Electrostatic Damage,
publication 8000-4.5.2
or any other applicable ESD protection handbook.
To Next Page
Loading...
Need help?
General
