EasyManuals Logo
Home>Alpine>Car Receiver>CDE-W235EBT

Alpine CDE-W235EBT User Manual

Alpine CDE-W235EBT
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
2
Turn the Rotary encoder to select SHUFFLE ALL, and then
press
s
/ENTER.
The “ ” indicator lights up.
To cancel Shue ALL mode, press /SHUFFLE 5 to select OFF.
Repeat Play
In Case of Diculty
1
2
Press /REPEAT 4
The song is played back repeatedly.
To cancel repeat play, select (o) with the above procedure.
*
Repeat One.
Only Repeat One is available for the iPod/iPhone.
If you encounter a problem, please turn the power o, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. is guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
Repeat One:
A single song is repeatedly played back.
Note
Note
-
-
-
-
-
-
-
-
-
-
-
-
-
If Shue ALL is selected, the selected songs being played back in the
search mode are cancelled.
During repeat playback, no other songs are selectable by pressing
w
or
e
.
Vehicles ignition is o.
No antenna or open connection in cable.
Out of operating temperature range +50°C (+120°F) for CD.
Moisture condensation in the CD Module.
A CD is already in the CD player.
You are in a weak signal area.
e antenna may not be the proper length.
If the area you are in is a primary signal area, the antenna may not be
grounded and connected properly.
e antenna is not the proper length.
e antenna is poorly grounded.
Improper power lead (Red) and battery lead (Yellow) connections.
Blown fuse.
Internal micro-computer malfunctioned due to interference noise
etc.
If connected following instructions, the unit will not operate with
the vehicles ignition o.
Make sure the antenna is properly connected;
replace the antenna or cable if necessary.
Allow the vehicles interior (or trunk) temperature to cool.
Allow enough time for the condensation to evaporate (about 1
hour).
Eject the CD and remove it.
Make sure the tuner is in the DX mode.
Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Extend the antenna fully; replace it if it is broken.
Make sure the antenna is grounded properly at its mounting
location.
Check power lead and battery lead connections.
Check the fuse of the unit; replace with the proper value if
necessary.
Press the
RESET
button with a ballpoint pen or other pointed
article.
*
28
-EN
Information
Basic
Radio
CD
No function or display.
Unable to receive stations.
CD Player not functioning.
CD playback sound is wavering.
CD insertion not possible.
Unable to tune stations in the seek mode.
Broadcast is noisy.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alpine CDE-W235EBT and is the answer not in the manual?

Alpine CDE-W235EBT Specifications

General IconGeneral
BrandAlpine
ModelCDE-W235EBT
CategoryCar Receiver
LanguageEnglish

Related product manuals