Alpine CDE-W235EBT User Manual

-
-
-
-
-
-
-
-
Communication error.
FM TUNER SECTION
AM TUNER SECTION
CD PLAYER SECTION
PICKUP
USB SECTION
BLUETOOTH SECTION (CDE-W235EBT only)
GENERAL
CHASSIS SIZE
Tuning Range
Tuning Range
Frequency Response
Wave length
USB requirements
BLUETOOTH Specication
Power Requirement
Width
Height
Depth
Mono Usable Sensitivity
Sensitivity (IEC Standard)
Wow & Flutter (% WRMS)
Laser power
Max. Power Consumption
Output Power
USB Class
Prole
Maximum Power Output
Maximum Pre-Output Voltage
Bass
Treble
Loudness
Weight
File System
MP3 Decoding
WMA Decoding
Number of Channels
Total Harmonic Distortion
Dynamic Range
Signal-to-Noise Ratio
Channel Separation
Alternate Channel Selectivity
Signal-to-Noise Ratio
Stereo Separation
Capture Ratio
87.5~108.0 MHz
531~1,602 kHz
5~20,000 Hz (±1 dB)
795 nm
USB 1.1/2.0
BLUETOOTH V 3.0
14.4 V DC
178 mm (7")
100 mm (3–15/16")
160 mm (6–1/4")
9 dBf (0.8 µV/75 ohms)
22.5 µV/27 dB
Below measurable limits
CLASS I
1,000 mA
+4 dBm Max. (Power class 2)
(11~16 V allowable)
Mass Storage
HFP (Hands-Free Prole)
50 W × 4
FAT 12/16/32
HSP (Head Set Prole)
2 V/10 k ohms
MPEG AUDIO Layer-3
A2DP (Advanced Audio
±14 dB at 100 Hz
Windows Media™Audio
Distribution Prole)
±14 dB at 10 kHz
2-Channel (Stereo)
AVRCP (Audio/Video
10 dB at 100 Hz
Remote Control Prole)
1.618 kg (3 lbs. 9 oz)
0.008% (at 1 kHz)
95 dB (at 1 kHz)
105 dB
85 dB (at 1 kHz)
80 dB
65 dB
35 dB
2.0 dB
Communication error.
Caused by the iPod/iPhone Soware Version not being compatible
with this unit.
e iPod/iPhone is not veried.
Turn the ignition key o, and then set to ON again.
Turn the ignition key o, and then set to ON again.
Reset the iPod.
Reset the iPod.
Check the display by reconnecting between the USB Memory
and this unit.
Check the display by reconnecting between the iPod/iPhone and
this unit, using the iPod/iPhone cable.
Update the iPod/iPhone Soware Version to be compatible with
this unit.
Try another iPod/iPhone, if available.
-
-
Power surge error.
Excessive voltage/current is supplied to the USB Memory.
Power surge error.
Excessive voltage/current is supplied to the iPod/iPhone.
Try another USB Memory, if available.
Try another iPod/iPhone, if available.
•
•
•
•
•
•
•
•
-
-
e iPod/iPhone is not connected.
e BLUETOOTH device is not connected.
Make sure the iPod/iPhone is correctly connected (refer to
“Connections” on page 33).
Make sure the cable is not bent excessively.
Connect the BLUETOOTH device.
Indication for iPod Mode
BLUETOOTH mode (CDE-W235EBT only)
NO DEVICE
•
-
ere are no songs in the iPod/iPhone.
Download songs to the iPod/iPhone and connect to this unit.
Specications
Note
•
Due to continuous product improvement, specications and design are
subject to change without notice.
30
-EN

Alpine CDE-W235EBT Specifications

General

Brand	Alpine
Model	CDE-W235EBT
Category	Car Receiver
Language	English