106
use and maintenance RSV mille ! - RSV mille R !
CHANGING THE REAR LIGHT
BULB
Carefully read p. 102 (BULBS).
NOTE The rear light houses two parking
light/stoplight bulbs (1).
The following operations refer to a single
bulb, but are valid for both.
Before changing a bulb, check the efficien-
cy of the stoplight switches, see p. 98
(CHECKING THE SWITCHES).
◆ Position the vehicle on the stand, see p.
58 (POSITIONING THE VEHICLE ON
THE STAND).
◆ Unscrew and remove the two screws (2).
◆ Remove the protection screen (3).
NOTE Upon reassembly, correctly posi-
tion the protection screen in its seat.
Tighten the screw (2) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
◆ Press the bulb (1) slightly and rotate it
anticlockwise.
◆ Extract the bulb (1) from its seat.
Insert the bulb in the bulb socket,
making the two bulb pins coincide with
the relevant guides on the socket.
◆ Correctly install a new bulb of the same
type.
1 3
2
1
To Next Page
Loading...
Need help?
General
