20
use and maintenance RSV mille ! - RSV mille R !
MULTIFUNCTION COMPUTER
When the ignition key (1) is rotated to posi-
tion “B”, the following warning lights come
on on the dashboard:
– red line warning light LED “max” (2);
– red engine oil pressure warning light
LED “P” (3), which remains on until the
engine starts.
The pointer (4) of the revolution counter
shifts to the maximum value (rpm) set by
the user. After about three seconds the
red line warning light LED "max" (2) goes
off; the pointer (4) of the revolution counter
returns to its initial position.
The writing "
EFI" (5) appears on the right
side of the multifunction display for three
seconds.
In this way the component operation is
tested.
After the first 1000 km and successively
every 7500 km, the writing “SERVICE”
(5a) appears on the right display.
In this case contact an aprilia Official
Dealer, who will carry out the opera-
tions indicated in the regular service in-
tervals chart, see p. 60 (REGULAR
SERVICE INTERVALS CHART). To
make the writing “SERVICE” disappear,
press the “LAP” push button (6) and
then the push button
S
and keep them
pressed for about five seconds.
With the ignition key (1) in position "B" the
standard settings on the dashboard are the
following:
Right display: Clock (7), coolant tempera-
ture in °C (8).
Left display: Instantaneous speed in
km/h (9), trip 1 (trip odometer) (10), total
kilometres/ odometer (11).
Upon installation of the battery or of the
30A main fuses:
– the revolution counter pointer (4) makes
twelve clockwise clicks, thus checking the
operation of the revolution counter itself;
– the instantaneous, maximum and aver-
age speed function is set in “km/h”;
– the coolant temperature is set in °C;
– the digital clock is set to zero;
– the red line is set at 6000 rpm, indicated
by the coming on of the red line warning
light LED “max ” (red) (2).
NOTE If necessary, carry out the appro-
priate adjustments.
SEGMENT OPERATION CHECK
◆ Press the push buttons T and U at the
same time.
◆ Rotate the ignition key (1) from position
“C” to position “B”.
All the segments (13) (13a) will remain on
until the push buttons T and U are re-
leased.
To Next Page
Need help?
General
