27
use and maintenance RSV mille ! - RSV mille R !
The high beam blinking is operated by pressing the push but-
ton, independently of the position of the light switch (I - J
-
•
).
NOTE To disconnect the high beam blinking, release the push
button.
6) COLD START LEVER (A)
The starter for the cold start of the engine is operated by ro-
tating the lever “A” downwards.
To disconnect the starter, move the lever “A” to its initial posi-
tion.
CONTROLS ON THE RIGHT PART OF THE
HANDLEBAR
NOTE The electrical parts work only when the ignition switch
is in position “B”.
7) ENGINE STOP SWITCH (LB - MC)
Do not operate the engine stop switch "LB - MC" in run-
ning conditions.
This is a safety or emergency switch.
When the switch is in position "LB", it is possible to start
the engine; the engine can be stopped by moving the switch
to position "MC".
With stopped engine and ignition switch in position "LB",
the battery may discharge.
When the vehicle has come to rest, after stopping the en-
gine, move the ignition switch to position “MC”.
8) START PUSH BUTTON (K)
When the start push button “K” is pressed, the starter makes
the engine run. For the starting, see p. 50 (STARTING).
To Next Page
Loading...
Need help?
General
