Ariston 100 L Technical Manual

Other materials (not supplied):
•
5 pin power cable (4 x 0,75 mm² + ground cable) long enough for the connection between internal and external units
•
Hole saw for concrete ø60 mm, if the installation involves making a hole
•
Pipes and fittings for hydraulic connection
• Rawlplugs
and screws specific for concrete walls, for external unit installation
• Rawlplug
s, bichromatic screws, nuts and washers (M10, M12 or M14) specific for concrete wa
installation
•
It is mandatory to fit a safety valve onto the appliance’
1487:2002 standard and must have a maximum pressure of 0.7 Mpa (7 bar). Moreover, it must at least include the
following components: a cut-
off valve, a non
valve and a water pressure shut-
off device
• S
afety devices like thermostatic mixing valve, pressure reducer, expansion vessel
•
Generic tools: screwdrivers, meter, driller, cutter,
Available installation accessories
Internal unit SAFETY HYDRAULIC
GROUP
External unit
FLOOR STANDING SUPPORT KIT FOR EXTERNAL UNIT
WALL HUNG SUPPORT KIT FOR
APPENDIX B: ROUTINE MAINTENANCE
•
It Is mandatory to clean the evaporator on an annual basis in order to remove any dust or obstructions
evaporator, placed on the external unit, it is necessary to remove the fixing screws of the grid casing; clean the evaporator
with a flexible brush taking care not to damage it.
•
In the case you found some bended fins, straighten them with
•
Still on external unit, ensure that the condensate water runs out in a suitable drain and make sure the discharge is made
without hindrance.
•
The pressure safety device must be operated regularly to ver
deposits.
•
Check that the condensate drainage pipe is not obstructed.
This product conforms to EU Directive 2002/96/EC.
The barred dustbin symbol appearing on the appliance’s data plate indicates that the product must be disposed of separately f
once it reaches the end of its lifespan, and transferred to a waste disposal site for electric and electronic e
purchasing a new appliance of the same kind. The user is responsible for delivering the decommissioned appliance to a suitabl
separated collection of the decommissioned appliance and its
effects on the environment and health and favors the reuse of the materials comprising the product. For further details on th
system
s, contact your local waste disposal office, or the dealer from which the product was purchased.
39
5 pin power cable (4 x 0,75 mm² + ground cable) long enough for the connection between internal and external units
Hole saw for concrete ø60 mm, if the installation involves making a hole
Pipes and fittings for hydraulic connection
and screws specific for concrete walls, for external unit installation
s, bichromatic screws, nuts and washers (M10, M12 or M14) specific for concrete wa
It is mandatory to fit a safety valve onto the appliance’
s water inlet pipe. The device must comply with the EN
1487:2002 standard and must have a maximum pressure of 0.7 Mpa (7 bar). Moreover, it must at least include the
off valve, a non
-
return valve, a control mechanism for the non
off device
; together with a dripping water discharge pipe.
afety devices like thermostatic mixing valve, pressure reducer, expansion vessel
Generic tools: screwdrivers, meter, driller, cutter,
scissors, gloves, 1/2” torque wrenches, Teflon...
GROUP
(For inlet pipe 1/2’’ )
FLOOR STANDING SUPPORT KIT FOR EXTERNAL UNIT
WALL HUNG SUPPORT KIT FOR
EXTERNAL UNIT
APPENDIX B: ROUTINE MAINTENANCE
It Is mandatory to clean the evaporator on an annual basis in order to remove any dust or obstructions
evaporator, placed on the external unit, it is necessary to remove the fixing screws of the grid casing; clean the evaporator
with a flexible brush taking care not to damage it.
In the case you found some bended fins, straighten them with
a special comb, according to the fins spacing (1.6mm).
Still on external unit, ensure that the condensate water runs out in a suitable drain and make sure the discharge is made
The pressure safety device must be operated regularly to ver
ify that it is not clogged and to remove any lime scale
Check that the condensate drainage pipe is not obstructed.
The barred dustbin symbol appearing on the appliance’s data plate indicates that the product must be disposed of separately f
once it reaches the end of its lifespan, and transferred to a waste disposal site for electric and electronic e
quipment, or returned to the dealer when
purchasing a new appliance of the same kind. The user is responsible for delivering the decommissioned appliance to a suitabl
separated collection of the decommissioned appliance and its
successive eco-
compatible recycling, treatment and disposal contributes to preventing negative
effects on the environment and health and favors the reuse of the materials comprising the product. For further details on th
s, contact your local waste disposal office, or the dealer from which the product was purchased.
5 pin power cable (4 x 0,75 mm² + ground cable) long enough for the connection between internal and external units
s, bichromatic screws, nuts and washers (M10, M12 or M14) specific for concrete wa
lls, for internal unit
s water inlet pipe. The device must comply with the EN
1487:2002 standard and must have a maximum pressure of 0.7 Mpa (7 bar). Moreover, it must at least include the
return valve, a control mechanism for the non
-return valve, a safety
scissors, gloves, 1/2” torque wrenches, Teflon...
□
□
□
□
□
□
□
□
It Is mandatory to clean the evaporator on an annual basis in order to remove any dust or obstructions
. To access the
evaporator, placed on the external unit, it is necessary to remove the fixing screws of the grid casing; clean the evaporator
a special comb, according to the fins spacing (1.6mm).
Still on external unit, ensure that the condensate water runs out in a suitable drain and make sure the discharge is made
ify that it is not clogged and to remove any lime scale
The barred dustbin symbol appearing on the appliance’s data plate indicates that the product must be disposed of separately f
rom household waste
quipment, or returned to the dealer when
purchasing a new appliance of the same kind. The user is responsible for delivering the decommissioned appliance to a suitabl
e waste disposal site. Proper
compatible recycling, treatment and disposal contributes to preventing negative
effects on the environment and health and favors the reuse of the materials comprising the product. For further details on th
e available waste collection

Ariston 100 L Specifications

General

Brand	Ariston
Model	100 L
Category	Water Heater
Language	English