Ariston 100 L Technical Manual

6
TECHNICAL DATA TABLE
Description
Unit of
measurement
80 L 100 L 110 L
INTERNAL UNIT
Rated tank capacity l 80 103 110
Insulation thickness mm ≈ 41 ≈ 41 ≈ 41
Type of internal tank protection enamelling
Type of corrosion protection titanium impressed current anode + disposable magnesium anode
Maximum operating pressure MPa 0,8
Diameter of hydraulic connections 1/2 M
Diameter of gas connections 1/4” & 3/8” flare type
Minimum water hardness °F 12 (with water softener, min 15°F)
Weight when empty kg 32 35 38
Heating element power W 1200 1200 1200
Protection rating IP24 IP24 IP24
Min. temperature of room of installation °C 1 1 1
EXTERNAL UNIT
Heat rating (*) W 1500
Average electrical power consumption (*) W 510
Max. electrical power consumption (*) W 750
Refrigerant connection diameter 1/4 & 3/8 flare type
Weight when empty kg 27
Standard air flow rate m3/h 1100
Sound power dB(A) 55
Level of sound pressure at 5 m dB(A) 39
Max. pressure of refrigerating circuit (low-
pressure side)
MPa 1.2
Max. pressure of refrigerating circuit (high-
pressure side)
MPa 2.7
Protection rating IP24
Minimum air temperature (***) °C -5
Maximum air temperature (***) °C 42
Gas connection maximum length m 6
Gas connection maximum drop m 3
Quantity of R134a refrigerant fluid g 700
PERFORMANCES
Unit of
measurement
80 L 100 L 110 L
COP (*) 2,9 2,9 2,9
Heating time with heat pump (*) h:min 2:45 3:26 3:42
Heating energy consumption (*) kWh 1,20 1,53 1,64
Max. amount of hot water
in a single intake V40 (**)
Delivered at 55°C l 95 130 144
Delivered at 62°C l 113 152 169
Max. water temperature with heat pump °C 62 (55 factory default) 62 (55 factory default) 62 (55 factory default)
Max. water temperature with heating
element
°C 75 (65 factory default) 75 (65 factory default) 75 (65 factory default)
QPr (over 24h) kWh 0,46 0,50 0,50
POWER SOURCE
Voltage / max. power consumption (*) V / W 220-240 single-phase / 1950
Frequency Hz 50
Max. current consumption A 8,5
(*) values obtained with air temperature of 7°C, 87% relative humidity; input water temperature 15°C, setting temperature 55 °C, in
compliance with EN255-3 norm.
(**) Performance measured for input water temperature 15°C.
(***) outside of the heat pump’s interval of operation, heating of the water is ensured by the heating element..
Average value obtained on a significant number of products.

Ariston 100 L Specifications

General

Brand	Ariston
Model	100 L
Category	Water Heater
Language	English