Revision A
24
A-3. QUICK SETUP REFERENCE
SETUP
To enter setup, press <
Δ> then <ENTER>
Press <
Δ> or <∇> then <ENTER> to select function, then <Δ> or <∇> to change
L0 Run
L1 Audible Alarm (On/Off)
L2 0 Sample Time (5 to 120 seconds)
L3 100% Sample Time (5 to 120 seconds)
L4 Decimal Places (3 or 4)
L5 Internal Reference (Current Selection Displayed)
L6 Hour Meter
L7 Factory Defaults
L8 Software Revision
L9 Bar graph (On/Off)
L10 Display Intensity
L11 Zero Purge Time (0 to 120 seconds)
L12 100% Purge Time (0 to 120 seconds)
AUDIBLE ALARM (ON) or (OFF)
<ALARM> Displays Status (On or Off ), <
Δ> or <∇> to change, <ENTER> to exit,
<ALARM> Pressed a second time before <ENTER>, displays Set Point, (0.010 by default) <
Δ> or
<
∇> to change.
<ENTER> Accept Alarm Set Point. Displays On/Off status again, <
Δ> or <∇> to change.
<ENTER> Accept status and return to RUN mode. Alarm LED will remain lit.
*Note: Use L1 to turn the audible portion of the alarm On or Off.
INTERNAL REFERENCE
Set Selector Valve to CLEAR
<REF> (Blinks)
<ENTER> Calibration reagent (PAO or DOP), also *USER or *HIGH
Use <Δ> or <∇> to change
<ENTER> Displays µg/l of concentration to be displayed as 100 when sampled.
Use <
Δ> or <∇> to change
<ENTER> (O Blinks)
Ready for Testing
To Next Page
Loading...
Need help?
General
