2 General description
2.1
General description
Introduction
SF 15
+
, SF 17
+
and SF 22
+
are stationary, oil free compressors.
Dependent on the model, the compressors have 3 or 4 electric motor driven compressor
modules, enclosed in a sound insulating canopy. The front door panel houses the Elektronikon
Graphic controller and the emergency stop button. An electric cabinet with the electric
components is installed behind the front panel. The compressors can be delivered with or without
integrated refrigerant air dryer.
SFD 11
+
, SFD 15
+
and SFD 22
+
are stationary, oil free compressors. They have a duplex setup
of the compressor compartment, existing of 1 or 2 active compressor modules and 1 or 2
compressor modules as backup, enclosed in a common sound insulating canopy. The front door
panel of each set of compressor modules houses the Elektronikon Graphic controller and the
emergency stop button. An electric cabinet with the electric components is located behind the
front panel of each module. SFD have no integrated air dryer.
SF
SF is the type designation of the compressor variant without integrated dryer. On SF, the
compressed air of each compressor module flows via an individual check valve to a common air
cooler and leaves the compressor via the air outlet valve.
SF Full Feature (SF FF) compressors are SF compressors provided with a refrigerant air dryer,
integrated in the bodywork. The dryer removes moisture from the compressed air by cooling the
air to near freezing point and automatically draining the condensate.
SF 22
+
FF, front view
1 Elektronikon Graphic controller S3 Emergency stop button
2 Electric cabinet DR Refrigerant dryer
Instruction book
10 2920 7140 52
To Next Page
Loading...
Need help?
General
