Atlas Copco TPS Control User Manual

TPS Control EN User guide
© Atlas Copco Industrial Technique AB - 9836 5819 01
49
A read-in label will be shown in the display of the TPS Control if it cannot be processed. A total of 200 la-
bels can be used in TPS Control.
All label data can also be printed out with the Print function.
Reporting function
Licensed function
The result reporting function is an optional licensed function and is activated with an activation code. Sec-
tion Licence handling [Page000] describes how to activate licensed functions.
Description
You can select between the following result reports:
■
Position report
Gives a result for every tightening position. If a Job has five tightening positions, a separate report for
each position is generated as well as a result report for the complete job.
■
Job report
Gives one result report for the complete job.
Procedure
To activate result reporting, perform the following procedure:
1. Press Setup>Sequence.
2. Select parameter Result Report and press OK.
3. Select if to activate a position report or job report. To deactivate function, select option Off.
4. Press VAL to confirm the selected option.
Printout
1. Connect TPS Control to a PC using the RS-232 interface.
2. In TPS Control, go to RS-232 setup and set parameter C1:baudrate.
Note! The same baud rate must be used in TPS Control and the PC.
3. On the PC, select All programs>Accessories>Communications>HyperTerminal from the start
menu. A new window will appear.
4. Enter a name for the communication with TPS and click OK. A new window will appear.
5. Click Cancel. The HyperTerminal window will appear.
6. Click Call in the HyperTerminal window. A new window will appear.

Atlas Copco TPS Control Specifications

General

Brand	Atlas Copco
Model	TPS Control
Category	Controller
Language	English