To Next Page

To Previous Page

TPS Control EN User guide

Number Part Description

1 Display The front panel has a configurable display. A power-save function de-

activates the backlight on the display if it is not used for a user-defined

period of time (in minutes).

The display is divided into three segments:

■

Upper part shows the last selected job/current job.

■

Middle part shows status information about ongoing operations.

■

Lower part shows the menu alternatives that can be accessed us-

ing the function keys.

2 Function keys Soft keys which function according to what is displayed on the display

screen.

3 ESC Use this key to cancel any ongoing jobs or parameter settings. When

cancelling parameter settings, no changes are stored in memory.

4 Left/Right arrow key Use these keys to display parameter options or to create/remove posi-

tions when programming new jobs.

5 INFO Press this key to get information about the TPS Control device ID,

firmware version and activated licensed functions.

6 START Use this key to start selected job.

7 Up/Down Arrow keys When in parameter list, use these keys to go up or down in the list to

select a desired parameter.

For selected parameter, use the up/down arrow keys to change the op-

tions of the parameter.

8 NOK Use this key to release the tool after a position has resulted in NOK

state and the tool is disabled. This is only used if parameter NOK ac-

knowledge has been set to ON.

9 RESET Use this key to stop the ongoing job during any time of the procedure

10 VAL Use this key to validate and store all changed parameters in memory

11 OK Use this key to open the list with possible options for a selected param-

eter or confirm the selected option for the parameter.

12 MENU Use this key to enter the setup menu parameters

Atlas Copco TPS Control User Manual

Questions and Answers: